![]() ![]() ![]() Note that the above products are not appropriate to rely on for the purpose of shifting an automatic transmission (such as the 4L60E) when a gear reduction transfer case is being used, since when the transfer case is shifted into low range, the vehicle speed will read between 2.0 and 2.72 slower than the transmission output shaft is actually going. Use this sensor when you are not using a cable-driven speedometer and sourcing your speed signal from the GM ECM to your electronic speedometer. This version is identical to the above, except it does not have provisions for a mechanical cable pass-through. It generates a usable signal required by modified GM PCM computers from 1993+ trucks to present and 1994+ cars (Vette, Camaro, Caprice), equivalent to 8,000 pulses per mile. This is a cable-pass-through style speed sensor that can be attached to the Jeep Dana and mechanical New Process transfer case outputs. This sensor ( VSS01-4160) will allow you to run a conventional cable drive speedometer and send critical speed data to your GM PCM for proper powertrain operation. ![]() Ford 1.8L - 2.5L "Pinto" Engines into the Jeep.Chevrolet, Buick & GM Engines into the Jeep. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |